K 10
svn:author
V 6
mjacob
K 8
svn:date
V 27
2003-09-13T01:55:44.000000Z
K 7
svn:log
V 523
On reset, make sure that we have some parameters set correctly. This
fixes a longstanding issue WRT resetting the chip after startup- it
would fail if we were connected as an F-port to a switch. If we
were connected as an F-port, we got assigned a hard loop ID of 255,
which is really a bogus loop id. Then when we turned around to
reset ourselves, the firmware would reject the ICB_INIT request
because the loop id was bogus. *sputter*

Minor fixlet from somebody in NetBSD with too much time on their
hands (dma -> DMA).

END