K 10
svn:author
V 9
jimharris
K 8
svn:date
V 27
2013-07-03T23:24:53.033600Z
K 7
svn:log
V 954
MFC r252262:

  For ATA_PASSTHROUGH commands, pretend isci(4) supports multiword DMA
  by treating it as UDMA.

  This fixes a problem introduced in r249933/r249939, where CAM sends
  ATA_DSM_TRIM to SATA devices using ATA_PASSTHROUGH_16.  scsi_ata_trim()
  sets protocol as DMA (not UDMA) which is for multi-word DMA, even
  though no such mode is selected for the device.  isci(4) would fail
  these commands which is the correct behavior but not consistent with
  other HBAs, namely LSI's.

  smh@ did some further testing on an LSI controller, which rejected
  ATA_PASSTHROUGH_16 commands with mode=UDMA_OUT, even though only
  a UDMA mode was selected on the device.  So this precludes adding
  any kind of mode detection in CAM to determine which mode to use on
  a per-device basis.

Note: The reasons behind this change do not apply to stable/7.  This MFC
is to keep the driver consistent across stable branches and current.

Sponsored by: Intel

END