K 10
svn:author
V 6
marius
K 8
svn:date
V 27
2014-04-22T13:02:12.793892Z
K 7
svn:log
V 1429
MFC: r229379

Add support for Intel EG20T serial ports

MFC: r248340

Add support for Exar XR17V358 8-port serial device to puc(4)

MFC: r248472

Correct the definition for Exar XR17V258IV: we must use a config_function
to specify the offset into the PCI memory spare at which each serial port
will find its registers.  This was already done for other Exar PCI serial
devices; it was accidentally omitted for this specific device.

MFC: r251713

Fix whitespace and normalize some entries.

MFC: r251715

All of Oxford/PLX OX16PCI954, OXm16PCI954 and OXu16PCI954 share the
exact same (subsystem) device and vendor IDs. However, the reference
design for the OXu16PCI954 uses a 14.7456 MHz clock (as does the EXSYS
EX-41098-2 equipped with these), while at least the OX16PCI954 defaults
to a 1.8432 MHz one. According to the datasheets of these chips, the
only difference in PCI configuration space is that OXu16PCI954 have
a revision ID of 1 while the other two are at 0. So employ the latter
for determining the default clock rates of this family.

MFC: r264257, r264327, r264514

Distinguish between the different variants and configurations of Sunix
{MIO,SER}5xxxx chips instead of treating all of them as PUC_PORT_2S.
Among others, this fixes the hang seen when trying to probe the none-
existent second UART on an actually 1-port chip.

Obtained from:	NetBSD (BAR layouts)
Sponsored by:	Bally Wulff Games & Entertainment GmbH

END